First, in the die-cutting processing process, often there are a series of problems, affecting the smooth production.

       Die-cutting MachiningFactoryOn the basis of the process principle, the common problems encountered in die-cutting processing and production are further analyzed, and the solutions are discussed, hoping that the actual die-cutting processing and production will be helpful.

(1) Die-cutting accuracy is not high

Deviation in die-cutting processing is a common problem in production. The precision of die-cutting is one of the important standards to measure die-cutting quality, and it is an important guarantee for qualified products. There are many reasons that affect die-cutting accuracy, such as mechanical reasons, die-cutting version of the problem, but also from print problems, operating environment, personnel operation problems and so on. Different problems should be solved in different ways.

(2) Die-cutting and paste version

The so-called hash version, refers toBubble cotton die-cuttingDie-cutting processing of waste edges and plates scattered and caused by the phenomenon of not smooth. When the bulk version is serious, it will affect the die-cutting and plate transmission, thus affecting the normal production. The main reason for the hash version is the error in the die-cutting plate making process and the selection of elastic strips (or sponges) when, at the same time, other factors may also cause a hash version. Die-cutting "paste version" refers to the board adhesion in the die-cutting version, can not be separated in time.

(3) Die-cutting when the edge is not smooth, the main reason for this phenomenon is related to the quality of the steel knife and die-cutting pressure,Because shockproof materials need different thickness and different shapes to combine to obtain a good distribution of resources, at this time it is necessary for die-cutting processing to transform it, the whole block of shockproof raw materials for cutting, stamping and other die-cutting processing technology.

(4) Explosion line (dark lines), burst line refers to the product in theMesh yarn die-cuttingDie-cutting processing or finished product folding, the plate by the die-cutting pressure is too large, exceeding the bearing limit of the plate fiber, so that the processing of the plate fiber fracture or partial fracture. "Dark lines" refers to an undeserved processing line. This is a frequent problem in die-cutting processing, especially in dry weather conditions, often occur.