Attention! In the process of die-cutting processing should pay attention to these places,Die-cutting MachiningFactoryIs that die-cutting is based on the predetermined shape, through precision machining and cutting to make the material to form a different size of custom parts. But what problems do I need to pay attention to in the die-cutting process?

First, version and version of the roller paste is not tight

Because the non-dry glue printing is the use of letterpress printing, printing will be the resin version with double-sided adhesive affixed to the surface of the plate roller. If the printing plate does not have a good overlay on the surface of the roller, resulting in the version of the interface upturned, compared to the die cutter version of the printing plate shorter.Address the causes of this phenomenonDie-cutting processing plantDo not allow the printing plate after the plate to roll this is conducive to the printing plate better paste on the plate roller surface.

Second, the pressure of printing

In the printing process, if the pressure over the assembly caused the resin version to be squeezed deformation, resulting in die-cutting processing and printing between the set is not allowed. In particular, the version of the material is relatively soft in the case of this phenomenon is more common.The phenomenon of the above version and the Round knife sleeve is more obvious on the electronic label which requires a high precision of die-cutting accuracy. Some labels even 5-8 modulus only 0.2-0.3mm tolerance, generally to die-cutting processing,Precision Die CuttingLabels that do not require a high level of accuracy are not obvious.